My husband replaced the positive battery cable on our 1994 ford explorer. After he changed the cable the truck witll start but it continues trying to start. Why is this happening?
Auto Repair Questions and Answers - Auto Repair Help - Ask A Question - Freeautomechanic.com
17 Feb, 2010 1 Comment
My husband replaced the positive battery cable on our 1994 ford explorer. After he changed the cable the truck witll start but it continues trying to start. Why is this happening?
10 Feb, 2010 2 Comments
SORRY TO AS AGAIN EVERY THANG CHECKS OUT HAVE GOOD GROUND BUT STEAL NOT GHARGE WERE WOULD I FIND THE BALLAST RESISTOR DOSE NOT SHOW ON MOTOR><THANK YOU 3.9 ENGINE
9 Feb, 2010 1 Comment
Had a 92 ford mustang 2.3L changed engine to the 5.0. After the engine change I noticed that the check engine and air bag light is flashing. Has anyone had this problem, what may be the cause? I read somewhere that it could be a module. What could it be, looking for specifics without having to take my engine apart again. Thank You.
6 Feb, 2010 1 Comment
I have a 98 Buick Century 3.1 litre v6. The odometer and gear selection Lights on the dash are just blank i need to know how to disconnect the gauge cluster ive got it out but i cant figure out how to disconnect it. any ideas????
4 Feb, 2010 1 Comment
I have 2003 trailblazer that has no taillights on the sides but do have in the center
the light bulbs are good and the fuses are good
30 Jan, 2010 1 Comment
Normally when the car is turned off the radio will stay on until you open the door. Now the radio and the clock in the dash will never turn off. The door switch is good. Any ideas?
25 Jan, 2010 4 Comments
21 Jan, 2010 1 Comment
When my headlights are on and I tap my brakes the radio goes off for about 5 secs. It also happens when I use my turn signal. It dosen’t happen all the time but very often.
18 Jan, 2010 1 Comment
2002 olds van, lower brake lights, traction control and cruise control not working. Have tried new brake light switch, cruise control module from a salvage yard and still not working. Have been told by several mechanics it was probably multi-function switch but have also been told if turn signals are working it wouldnt be that either.Any ideas
/
16 Jan, 2010 1 Comment
The cigarette lighter on my truck wasn’t working good. I got a new one, put it in, and now it blows the fuse. What could be wrong, and how do I test it to see if it is the new lighter or the wiring is bad?
Note: I only had two wires to attach to this lighter even though there were 3 places for wires to be attached to.
Thanks
Since 2006 Copyright Freeautomechanic.com | User Agreemant | Privacy Policy