Categories: Dodge

2005 dodge neon st automatic

I Just has my starter and battery replaced in my car and yesterday I go to turn start my car and nothing I checked the fuses the starter and the battery which is at 12.5

Keywords: neon
Christy Nicole Hendry

View Comments

  • The battery can show 12.5 volts and still be to weak to start the car. You need to confirm battery voltage at the "S" terminal on the starter while someone holds the ignition key in the "START" position. If you see battery voltage(and the battery load tests good) replace the starter. (possible to get a bad NEW part)

    The battery needs to be load tested to insure it is good. Using a 100 amp load tester works well for this. This is what I use.

Recent My Questions

2000 Honda Civic engine shutters and electrical accessories will stop working

When driving the gauges gyrate and the dash lights flicker. Under acceleration the headlights dim. After some driving distance, the…

1 week ago

LED Fog Light Upgrade Jeep Wrangler Video

Fog Light Replacement Unplug electrical connector from fog light assembly Remove 13mm retaining nut and washers from fog light under…

2 weeks ago

GM Low brake fluid warning light RECALL – How soon should I get it fixed?

If you haven't heard already, GMThe agency said that without the warning light, a vehicle may be driven with low…

2 months ago

Jeep Wrangler Frame Repair Kit Installation Video

https://youtu.be/Svf620OlWF0 This video is the rear section of the frame kit installation. https://youtu.be/Z7uBahE6hoY This video is of the center section…

2 months ago

02 Grand Caravan Sport

Hi, just following up on 02 Caravan: I was scanning with the newest up date and not the vin# so…

2 months ago