RESPONSE
First of all on this engine the pulley is part of the balancer. They are meant to be one unit. There is a rubber insert between the pulley and the outside of the balancer. As a result there is no way to re-install the outside pulley once it comes apart as it is a balanced unit. In conclusion a new replacement should be used if damage is found on the harmonic balancer.
The inertial weight section of the crankshaft balancer is assembled to the hub with a rubber type material. Therefore the correct installation procedures (with the proper tool) must be followed or movement of the inertial weight section of the hub will destroy the tuning of the crankshaft balancer.
Tighten
Tighten the crankshaft balancer bolt to 103 N·m (76 lb ft).
When driving the gauges gyrate and the dash lights flicker. Under acceleration the headlights dim. After some driving distance, the…
Fog Light Replacement Unplug electrical connector from fog light assembly Remove 13mm retaining nut and washers from fog light under…
If you haven't heard already, GMThe agency said that without the warning light, a vehicle may be driven with low…
https://youtu.be/Svf620OlWF0 This video is the rear section of the frame kit installation. https://youtu.be/Z7uBahE6hoY This video is of the center section…
Hi, just following up on 02 Caravan: I was scanning with the newest up date and not the vin# so…